Don't use open end fixed wrenches.

來源: jassco 於 2023-08-03 17:48:38 [] [舊帖] [給我悄悄話] 閱讀數 : (229 bytes)
回答: 螺絲太緊有點滑絲了，怎麽補救 由 DC_Jeeper 於 2023-08-03 16:33:28

Use an adjustable crescent wrench. File surfaces to make them flat. Use a hammer to hit the crescent wrench to create an impact. Spray some BP blaster penetrating oil if you have.

Good luck!

Alex

所有跟帖： 

• 謝謝，銼刀先銼平似乎有道理 -DC_Jeeper- ♂ 給 DC_Jeeper 發送悄悄話 (69 bytes) () 08/03/2023 postreply 18:12:13

• It is caused by -jassco- ♂ 給 jassco 發送悄悄話 (215 bytes) () 08/03/2023 postreply 20:08:37

請您先登陸，再發跟帖！