先試這招,簡單

1, charge your battery first to make sure voltage is higher than 12.6 after removed the float voltage.
2, remove battery negative cable first and the positive cable, tough both cable together for at least 15 second.
3, put ignition key in the cylinder and then to turn to the on position.

4, put positive cable back and then negative, tighten them enough.
5, start engine if it cranks good.

所有跟帖： 

• 3, 啟動擋鬆手後的擋位既是"on"檔. -fixanycars- ♀ (0 bytes) () 01/18/2010 postreply 20:45:44

• 好。明天試試，回頭再匯報。多謝，，， -曲線救國- ♂ (0 bytes) () 01/18/2010 postreply 21:03:01

• 中午試了一下，還不行 -曲線救國- ♂ (20 bytes) () 01/19/2010 postreply 13:35:35

• 3把鑰匙應該每把都試,如果全不能識別, 建議用GT1或SSS CODING/PROGRM -fixanycars- ♀ (120 bytes) () 01/19/2010 postreply 15:29:17

• 試時要把車門關好,HOOD 關好,如電平在TRUNK裏. -fixanycars- ♀ (0 bytes) () 01/19/2010 postreply 15:31:24

• 現在隻有一把鑰匙。 -曲線救國- ♂ (201 bytes) () 01/19/2010 postreply 15:47:37