試一下土辦法,很多年前的技巧,記得也許不準

1, identify the start relay at power center, remove it and ignition key on, the connect female pin #30 and # 87 with a cross wire, car will crank, take it off until engine start, put the relay back on the socket, drive for 5 minute, shut off engine. try to start later.
2, locate ecm, it is normally located on the front of firewall, pass. side, behind shock tower. there are 3 or 4 boxes, don't confuse, you need find engine control module. check pin #66 green wire that is for start control, cut the wire after ignition key off and battery negative cable removed. put negative cable back and try to start engine. this will disable the anti-theft system.
3, make sure battery fully charged, clear security system code with a scanner, GT1, or MT2500 with euro software, Vedis, or Solus pro, etc. try to start engine.

所有跟帖： 

• 防盜係統鎖了,亂拔保險絲惹的禍. -fixanycars- ♀ (0 bytes) () 01/18/2010 postreply 19:11:11

• 剛想起,方法2時, 連接BATTERY負級線前應IGNITION KEY ON -fixanycars- ♀ (0 bytes) () 01/18/2010 postreply 19:22:30

• 需要解釋一下， -曲線救國- ♂ (204 bytes) () 01/18/2010 postreply 20:19:01

• 先試這招,簡單 -fixanycars- ♀ (406 bytes) () 01/18/2010 postreply 20:39:09

• 3, 啟動擋鬆手後的擋位既是"on"檔. -fixanycars- ♀ (0 bytes) () 01/18/2010 postreply 20:45:44

• 好。明天試試，回頭再匯報。多謝，，， -曲線救國- ♂ (0 bytes) () 01/18/2010 postreply 21:03:01

• 中午試了一下，還不行 -曲線救國- ♂ (20 bytes) () 01/19/2010 postreply 13:35:35

• 3把鑰匙應該每把都試,如果全不能識別, 建議用GT1或SSS CODING/PROGRM -fixanycars- ♀ (120 bytes) () 01/19/2010 postreply 15:29:17

• 試時要把車門關好,HOOD 關好,如電平在TRUNK裏. -fixanycars- ♀ (0 bytes) () 01/19/2010 postreply 15:31:24

• 現在隻有一把鑰匙。 -曲線救國- ♂ (201 bytes) () 01/19/2010 postreply 15:47:37