回複：I set to Cable select, it is

來源: 要注意 於 2004-11-04 11:47:01 [] [舊帖] [給我悄悄話] 本文已被閱讀： 次 (184 bytes)
回答: you need to set the jumper 由 correctly 於 2004-11-04 05:36:46
If you connect both hard drives on the same IDE cable then both hard drives have to be set to CS. This way the system will assume the hard drive on the end of the cable is the primary.
請您先登陸，再發跟帖！