Honda Accord Distributor O Ring Replacement

zwang1822 · 2012-03-07 07:57:55Z

Honda Accord Distributor O Ring Replacement簡介

來源: zwang1822 於 2012-03-07 07:57:55 [檔案] [博客] [舊帖] [給我悄悄話] 閱讀數 : (6004 bytes)

本文內容已被 [ zwang1822 ] 在 2012-03-07 08:31:28 編輯過。如有問題，請報告版主或論壇管理刪除.

1. Disconnect the negative cable from the battery;
2. Mark the location of each wire, then take ignition wires off the distributor cap.

3. Rotate engine from this hole by using 19mm socket.

4. Get the piston in the No. 1 cylinder to the Top Dead Center (TDC) spot.

5. Make sure rotor is pointing to No. 1 cylinder cable position.

6. Make the marks between distributor housing and engine block.

7. Carefully take distributor out from the engine.

10. Clean the parts and install the new o ring to the distributor and the install the distributor to the engine.

11. Connect all wire and cables and you are done !

請閱讀更多我的博客文章>>>