Car back to life

the day before yesterday i had this http://bbs.wenxuecity.com/auto/484345.html.

today i decided to tackle it.

dropped the skid, quickly noticed the wires having been chewed.  pulled the loom and took this pic

 

 

took the terminal out.  the green wire was a trouble - not possible to solder.  pryed out the top end:

 

solder an extension:

 

went under the belly, and soldered the wires to where each belongs.  heat shrank all connections.  plugged the terminal to the socket

test - turned engine on, no error message. drove around, no issues.

now, i need to go home depot to get something to repel those creatures at least for tonight and next few days until i get jt eaton 709.  

a happy ending... thank you all!

 

 

 

 

所有跟帖： 

• good. -biglow- ♂ (0 bytes) () 12/01/2018 postreply 18:53:51

• lessons learnt :-) -老生長談- ♂ (0 bytes) () 12/01/2018 postreply 19:16:41

• 在車下電焊，比較費力吧。我在桌麵上都焊接不好。 -色大膽小- ♂ (0 bytes) () 12/02/2018 postreply 09:23:24

• 是不容易。耐心起了作用 ：) -老生長談- ♂ (0 bytes) () 12/02/2018 postreply 11:03:41

• 很簡單我所有的wire都是solder -別在窗前等我- ♂ (0 bytes) () 12/03/2018 postreply 01:08:00

• Yep, I like soldering better than crimping, even on solar connec -老生長談- ♂ (0 bytes) () 12/03/2018 postreply 12:29:12

• 膠帶可能過段時間就鬆了，可以試試熱縮管 -duck2017- ♂ (0 bytes) () 12/03/2018 postreply 20:41:11

• 我都用的縮管（heat shrink), 最後把3條線用膠帶並到一起防止互相磨擦。最後的膠帶頭是用了超級膠防止鬆開：） -老生長談- ♂ (0 bytes) () 12/03/2018 postreply 21:59:07