回複：可能是光盤或者光驅的問題。

The new drive is 160g. I did a scandisk/surface on it and stopped when it passed
20% and no error.
I then formatted the disk again. During the process it gave a message:

verifying 21,55.31m ( what is this?)

and at the end these messages:

152,588.03m total disk space
152,588.03m available on disk.

I assume it sees the whole disk.

Then I did an install and got the same error. The exact warning message is --

"warning: windows did not finish loading on previous attempt. Choose safe mode to
start windows with a minimum set of drivers."

I also have a secondary disk (80g). On the bios setup utility it shows these properties
for it:

cylinders 39237
heads 16
write presentation
sectors 255

but for the new disk it shows nothing:

cylinders
heads
write presentation
sectors

Should I partition the new disk into smaller parts with fdisk?
--------------------