回這個封條隻起裝飾作用

the sealer is a paste.  before windshield was put on, the installer used a applicator (like a grease gun) to put the sealer in a shape of strip along the to-be lower edge of the windshield.  when the glass was set, the sealer would seal off moisture/water.  at the end, they put a rubber strip to the groove and make it look good.

if you really want it, dealer has it, or call auto glass companies to buy one.  it's inexpensive. from your pic, if it is still intact, just go get a rubber glue (homedepot has a tube) and glue it back.  it will not affect water tightness.  good luck.
 

所有跟帖： 

• 明白了，再問一下！這個rubber glue是在homedepot買好，還是在auto parts買好？ -ouyanghui- ♂ (69 bytes) () 02/16/2014 postreply 13:17:53

• HD 買就可以了。噪聲大與它無關。可能需要tune up -老生長談- ♂ (119 bytes) () 02/16/2014 postreply 13:45:58

• 2008年的toyota -ouyanghui- ♂ (0 bytes) () 02/16/2014 postreply 14:10:43

• 到junk yard去拆一個同年同款的裝上即可。 -US_CAR.- ♂ (0 bytes) () 02/16/2014 postreply 16:20:28

• 沒看清，脫了粘上，丟了才需要另找， -US_CAR.- ♂ (0 bytes) () 02/16/2014 postreply 20:21:44